1,Treble amplifier and subwoofer combination , so that the tweeter in the ongoing work under high load .

2,Now speakers are usually dispensed individually designed and sold , rather than and amplifier match together. Thus, if you choose properly, it will probably due to mismatch of the entire system damage.

3,Bass amp for some reasons in the operation of the overload current shock who were received . This problem during playback of the tone having a relatively wide range of high -density optical disc homeostasis sometimes occur .

4,Including high- density disc , including digital voice recorders , high-frequency material having reset function accent speakers produce specific frequency tone ; if the potentiometer adjustment improperly, causing damage to the speaker .

5,Accidental or sudden treble treble will produce large current damage tweeter ;

6,Accidental or sudden screams will produce large current damage treble tweeter ;

7,Microphone position mutation will produce self-excited howling treble tweeter high-current damage ;

8,Drop the microphone and collision will produce a large current treble damage tweeter ;

9,Electric plug a microphone or signal line will produce a large current damage treble tweeter ;

10,Sudden increase in volume will produce a large current damage treble tweeter ;

11,Power surge voltage instability or interference generated large current damage treble tweeter ;

Any of the above conditions can damage the woofer high school, once damaged, the entire sound system will be forced to stop using, because of their size, heavy weight, repair and maintenance is very inconvenient, it must sound speakers and high school circuit overcurrent timely and effective protection, in order to avoid these problems be sure to use.
 

1, the most commonly used is a one-time fuse, speaker system protection requirements more stringent.       Ordinary fuse from the speaker only disposable protective effect , the product failure rates rise ; addition, extra fuse box and wires to make the manufacturer's costs. Also, the use of fuses must also comply with specifications, wrong fuse causes speaker damage.
 

2, the installation breaker is a solution ; however, they have not disconnected before you start making noise when switched off .
 

3, using the unit circuit protection program, which is very good, but need to sampling , amplification, compared with the control waits for a series circuit , not only the number of components and more, procurement costs are high , but high failure rate, production debugging difficult, general seldom used.
 

4 , using a small resistor in parallel with a small light bulb ways of doing protection circuit , the circuit is simple , but the loss, in addition to simple sound outside is generally not used .
 

The protection methods have advantages and disadvantages , and recommend the best , most direct , most reliable and cost-effective solution is to use "WHPTC resettable fuse element " resettable fuse in the off state ( high-impedance state ) when the equivalent of a soft switch the failure to eliminate , it will automatically revert to the state of low resistance path .